0-1 Inch/0-25.4mm, .00005 Inch/0.001mm, Digimatic Micrometer Head, .375 Inch Diameter Plain Stem, Flat Carbide Tipped Spindle Face, Ratchet Stop

350-351-30

0.118 Inch (3mm) Diameter Rod Anvil for Uni-Mike

201217

0-1 Inch Measuring Range, 0.001 Graduation, Ratchet Thimble, Carbide Face, 15 Degree, Point Micrometer

112-189

110 x 110mm Comparator Stand, For Indicators and Linear Gages, Serrated Anvils, 3/8 Inch and 8mm Diameter Stem Holes, 275mm Travel, With 1mm Fine Feed Adjustment

215-405-10

0.7 Inch - 1.4 Inch Dial Bore Gage, Indicator Not Included

511-731

0.40 Inch - 1.2 Inch, 0.0002 Inch, Dial Caliper Gage

209-352

0-4 Inch Measuring Range, Ratchet Thimble, 2.5 Inch Base, Mechanical Depth Micrometer

129-127

0-6 Inch Measuring Range, 0.001 Graduation, Ratchet Thimble, Carbide Face, Interchangeable Anvil Micrometer

104-137

1-2 Inch, .0001 Inch Mechanical Outside Micrometer, Hammertone Baked Enamel, Ratchet Stop, Angle Frame

103-262

1.6 Inch - 2 Inch, 0.00005 Inch, Digimatic Holtest, Titanium Nitride Coated Contact Points, With SPC Output, Ratchet Stop

468-269

2.5 Inch - 3 Inch, 0.00005 Inch, Digimatic Holtest, Titanium Nitride Coated Contact Points, With SPC Output, Ratchet Stop

468-271

0 Inch -1/4 Inch, 0.001 Inch, Mechanical Micrometer Head, 1/4 Inch Diameter Stem with Clamp Nut, Flat Spindle Face

148-204

150 x 150mm Comparator Stand, For Indicators and Linear Gages, Serrated Anvils, 3/8 Inch and 8/20mm Diameter Stem Holes, 275mm Travel, With Fine Feed Adjustment Over Entire Travel

215-505-10

0.03 Inch, Dial Test Indicator, Full Set 0-15-0, 0.0005 Inch Graduation, 3/8 Inch Stems, 0.079 Inch/.039 Inch/.118 Inch Contact Points, Clamp and Hold Bar, 19.9mm Length, Anti-Magnet, Jeweled Bearing

513-402T

0 Inch -1 Inch Outside Diameter, 0.055 Inch - 1.05 Inch Inside Diameter, 0.001 Inch, Mechanical Groove Micrometer, 0.25 Inch Diameter Flange, Non-Rotating Spindle

146-231